Configure the STUDIO-CAPTURE in your computer:.NOTE: Connect the two USB cables to USB ports that are near each other. Connect the both STUDIO-CAPTURE units to the computer.In order to digitally synchronize the two units, use a digital coaxial cable to connect the second unit’s COAXIAL OUT (9/10) to the first unit’s COAXIAL IN (15/16).Set the first unit to the same sampling rate as the second unit and then make the following settings in the SYSTEM screen:.Switch on the power to the first STUDIO-CAPTURE unit.Use the CURSOR arrow buttons and VALUE knob to make the following system settings:.Turn the VALUE knob to change the sample rate to a desired setting. Use the CURSOR arrow buttons to choose “SAMPLE RATE.”Ĭ. Press the VALUE knob to access the SYSTEM screen.ī. Specify the sampling rate of your choice:Ī.The second STUDIO-CAPTURE unit will be the timing master. Switch on the power to the second STUDIO-CAPTURE unit.When using two units, they cannot be used with the 96 and 192 kHz setting.īefore you start making settings, disconnect both STUDIO-CAPTURE units from the computer and turn off their power.A maximum of two STUDIO-CAPTURE units can be synchronized.You may install the driver from the included setup disc or download the driver by clicking here.
The STUDIO-CAPTURE driver must be installed prior to following the setup below.
#AGGREGATE DEVICE FOR USB MIDI MAC MAC OS#
The following procedure will guide you through setting up two STUDIO-CAPTUREs to be used simultaneously with Mac OS X. If you connect two STUDIO-CAPTURE units to a computer, you’ll be able to use them as a 32-in/20-out audio interface.
0 kommentar(er)
